Two-part adhesive based on modified epoxy resin for flexible bonding and sealing applications. Specifically designed when self-extinguishing and thermal conductivity properties are required, it fully adheres to plastics like PA, ABS, PC, PET, PMMA, PI, metals, ceramics and composites. After full curing the adhesive looks tough and flexible and provides high peeling strength and temperature resistance up to +120°C with peaks to +150°C.
One component moisture curing acetic silicone sealant by reaction. Suitable for sealing gear boxes, pumps, motors and compressors flanges, hot fluid pipes. Provides an extremely flexible gasket between surfaces and resists to vibrations, thermal shocks, water, gas, LPG, oils and several chemicals. Keeps its sealing properties within temperatures of - 60° and + 250°C with peaks up to 300 °C. Sealed parts can be disassembled using normal tools.
It cleans, degreases parts and speeds up anaerobic adhesives and sealants fixture time. Curing effect is obtained in 20 - 120 seconds depending on type of adhesive, gap between parts and room temperature; wait for solvent evaporation before assembling parts. It can be used either on flange or threaded joints; its use might reduce final mechanical strength. The Activator is applied on one surface and let to dry for a few seconds.
Solvent free Activator to set up polymerisation of acrylic adhesives. Good polymerisation effects on ferrites, metals and ceramics. Fixture time about 1-2 minutes.
Solvent free Activator to speed up the setting time of anaerobic adhesives and sealants. Curing effect is obtained in 20 - 120 seconds depending from type of adhesive, gap between parts and room temperature. Apply the Activator to one surface and the anaerobic Adhesive to the other one. As it is solvent free there is no need to wait before assembling; it’s not harmful. It can be used either on flange or threaded joints; its use might cause a lowering of final mechanical strength.
To be used with acrylic adhesives and with anaerobics. Apply the Adhesive on one part and the Activator on the other; assemble parts and wait few minutes to achieve fixing.
Cleans, degreases parts and speeds up the setting time of cyanoacrylate adhesives. Curing effect is obtained in 1 - 4 seconds depending from type of adhesive, gap between parts and surfaces composition. The Activator is applied on one surface and let to dry for a few seconds
Cleaners and Removers Low odor Low volatility solvent Can detach and remove silicones, MS Polymers and two-part modified epoxy adhesives from many kinds of surfaces Available
Instant adhesive on basis of alcoxy-ethyl cyanoacrylate. Low odour not irritating, non blooming effect for appearance sensitive assemblies. Especially suitable to be used in non ventilated or closed areas. Delayed setting time allows adjustment of parts during assembly
Solvent based treatment for bonding of polyolefin (polyethylene, polypropylene), thermoplastic rubbers, EPDM, PTFE, silicones and other difficult to bond materials. Polyolefin Primer is recommended to be used with Loxeal 34 Instant Adhesive.