WORLD-RENOWNED ITALIAN BRAND
QUALITY & SAFETY ASSURED
Loxeal Engineering Adhesives is known for its adhesives and sealants for over 35 years. We are proud to distribute the Loxeal products to you.
Contact UsADHESIVE AND SEALANT APPLICATION
PROFESSIONAL
We have over 20 years of experience in this field with professional knowledge, to help you with appropriate solutions.
Contact Us
Very high temperature (+230° C) resistant, high strength anaerobic adhesive for locking and sealing thread connections and fitted parts. High viscosity and thixotropic effect allow larger tolerances. Highly resistant to corrosion, vibrations, water, gases, oils, hydrocarand many chemicals.
DIN DVGW approved thread sealant for gas (according to DIN EN 751-1 Reg. Nr. NG - 5146AT0264).
Very high temperature (+ 230°C) resistant, high strength anaerobic adhesive for locking and sealing thread connections and fitted parts. High viscosity and thixotropic effect allow larger tolerances. Highly resistant to corrosion, vibrations, water, gases, oils, hydrocarand many chemicals.
DIN DVGW approved thread sealant for gas (according to DIN EN 751-1 Reg. Nr. NG – 5146BQ0496).
A high viscosity gap filling silver paste used between machinery parts to repair worn areas and restore correct fits. It repairs worn shaft and housing, bearing spinouts, wallowed keyways and splines, threaded parts. Highly resistant to heat, vibrations, corrosion, water, gas, oil hydrocarbons many chemicals.
It cleans, degreases parts and speeds up anaerobic adhesives and sealants fixture time. Curing effect is obtained in 20 - 120 seconds depending on type of adhesive, gap between parts and room temperature; wait for solvent evaporation before assembling parts. It can be used either on flange or threaded joints; its use might reduce final mechanical strength. The Activator is applied on one surface and let to dry for a few seconds.
Solvent free Activator to set up polymerisation of acrylic adhesives. Good polymerisation effects on ferrites, metals and ceramics. Fixture time about 1-2 minutes.
Solvent free Activator to speed up the setting time of anaerobic adhesives and sealants. Curing effect is obtained in 20 - 120 seconds depending from type of adhesive, gap between parts and room temperature. Apply the Activator to one surface and the anaerobic Adhesive to the other one. As it is solvent free there is no need to wait before assembling; it’s not harmful. It can be used either on flange or threaded joints; its use might cause a lowering of final mechanical strength.
To be used with acrylic adhesives and with anaerobics. Apply the Adhesive on one part and the Activator on the other; assemble parts and wait few minutes to achieve fixing.
Cleans, degreases parts and speeds up the setting time of cyanoacrylate adhesives. Curing effect is obtained in 1 - 4 seconds depending from type of adhesive, gap between parts and surfaces composition. The Activator is applied on one surface and let to dry for a few seconds
Chemiseal 4X248 is UV-rays curing resin that is mainly consisting of urethance acrylic based resin and used for bonding. This product is an strong adhesive that is cured rapidly under irratiation of UV-rays of 300-400nm.
Chemiseal U-1546B is UV-rays curing resin that is mainly consisting of urethance acrylic based resin and used for bonding. This product is an strong adhesive that is cured rapidly under irratiation of UV-rays of 300-400nm.
Cleaners and Removers Low odor Low volatility solvent Can detach and remove silicones, MS Polymers and two-part modified epoxy adhesives from many kinds of surfaces Available